Why Use Gtechniq EXO?

Using composite siloxane technology, EXOv5 makes water spots and road grime easy to remove, offers excellent resistance to all wash chemicals and can help withstand micro-marring. It produces a high-gloss, warm-looking, extremely hydrophobic finish.

It has a consistent film that is more durable and resistant to road salt and washes chemicals than its predecessors. Application has been improved with just a single layer of product required, with a slow flash-off time, giving more time to achieve a perfect finish.

All of the above combined with the introduction of a good degree of swirl resistance means EXOv5 represents a significant leap forward in Last Surface Protection (LSP) technology. 

Simple Steps To Help You Get The Best Results

EXOv5 can be applied as a standalone coating or as a top layer for Gtechniq C1 Crystal Lacquer or Gtechniq Crystal Serum Light (CSL) – we recommend applying C1 or CSL as a base coat for easy-to-mark and dark paints

If you are applying over C1, EXOv5 should be applied a minimum of 4 hours, but less than 12 hours, after you finish the C1 application

If you are applying over CSL, EXOv5 should be applied at least 1 hour after application of the CSL.

Ensure that your vehicle is out of direct sunlight but warmer than 5 degrees Celsius, is completely dry and will stay dry for at least 12 hours after application
Wipe down all surfaces using Gtechniq Panel Wipe and a Gtechniq MF1 ZeroR Microfibre Buff Cloth (apply the Panel Wipe directly to the cloth and not directly to the panel) – if you are applying over newly applied C1 or CSL, this step is not required

Shake the bottle well and wear gloves

Prime the AP2 Ultra Soft Foam Filled Applicator evenly with a good amount of product so that the pad is saturated

Apply with the applicator provided in overlapping strokes to an area roughly 2ft by 2ft (60cm x 60cm). Wait for 1 to 2 minutes after applying to a panel and buff with an MF1, followed by a second MF1 to remove any smearing, leaving the surface slick. Just a single layer of product is required.

Allow the coating to cure for at least 12 hours before exposure to moisture

After application, we recommend that you do not wash the car for at least 7 days

Store in a cool, dry place

If opened, use within 3 months, if unopened, use within 12 months
 

Avoid direct application to plastic trims, rubbers and hard plastic, such as headlights & taillights.